Category Name, FPV Equipment, Walksnail Avatar
ORT Helical 3 Turn with Omni Stubby 5.8GHz Antenna 2 Pack Set
The ORT Helical 3 Turn 5.8GHz with Stubby Walksnail antenna set provides superior axial ratio performance compared to lower quality circular patch antennas and a high quality omni stubby. Its lightweight design makes it perfect for an FPV Goggles setup, and suitable for even the toughest RF environments, like those with buildings and trees that can block signals. Get industry-leading signal strength and penetration with ORT.
$79.99
Helical Antenna Features:
- Made in mind for the Walksnail/Fatshark Goggles
- Hand Tuned, providing wide beam width with 180 degree coverage and greater penetration through trees and dense material.
- High quality Enameled Supreme Wire (anti rust).
- Original Low loss RG402 cable.
- High quality acrylic, providing premium look.
- Effective range, 6~10km and beyond on 600mW Vtx (depends on flying area noise level, receiver sensitivity and FPV setup)
Helical Antenna Specifications:
- Freq Channel: 5300 ~ 6500 MHz
- Gain (dBi): 7 dBic
- SWR/S11: < 1:1.3
- Beam width: 150deg
- Polarization: Circularly Polarized – LHCP
- Gain Pattern: Directional (needs to be pointed in the general flying area)
- Connector: RP-SMA (Walksnail goggles V1 connector)
- Weight: 26.7g ea.
Stubby Features:
- Consist with set of 2 Micro Pagoda for Walksnail
- Smaller and compact antenna for easy use & storage
- Tested to have at least 30~40% better signal/higher bit rate(Mbps) than default antenna(higher efficiency).
Stubby Specifications:
- Gain : 1.2 dBic
- Axial Ratio <1.33(2.5dB)
- Efficiency : 95%
- Gain Pattern : omnidirectional (360° coverage)
- Polarization : LHCP (matched with Walksnail default antenna polarization)
- Connector : RP-SMA
Included:
- 2x ORT Helical 3 Turn 5.8GHz for Walksnail Goggles – LHCP
- 2x ORT Pagoda Stubby 5.8GHz Antenna Walksnail Goggles – LHCP
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
There are no reviews yet.