Category Name, Electronics, ELRS Receivers
RadioMaster RP1 2.4GHz ELRS v3 Nano Receiver
These RadioMaster nano receivers, developed by Jye Smith of ExpressLRS, have ESP8285 MCU and SX1280 RF chip. RP1 has a UFL antenna socket while RP2 has a built-in ceramic antenna, making it super light and small. Both have WIFI built in, allowing you to upgrade firmware and configure the Receiver via WebUI. Both RP1 and RP2 have low-latency, high-refresh-rate RF module, making them ideal for FPV and long-range. Furthermore, their ultra-light Nano size allows you to fit them anywhere, from whoops to fixed-wing models. The RP1 comes with ELRS Firmware V3 pre-installed.
Note: The packaging in this product will refer to ELRS V2 pre-installed, it has been confirmed ELRS V3 is pre-installed.
Availability:
11 in stock
$19.99
11 in stock
Features
- Improved PCB design is better for heat dissipation.
- ELRS Firmware V3 (pre-installed)
- LED on the top side of PCB.
- Solder pads are improved and easier to solder to.
- Open-source receiver based on ExpressLRS
- Upgraded rigid antenna with greater durability and performance
Specifications:
- Item: RP1 Nano ExpressLRS 2.4ghz Receiver
- Type: ISM
- Antenna: 65mm 2.4ghz T Antenna
- Maximum receive refresh rate: 500Hz / F1000Hz
- Minimum receiver refresh rate: 25Hz
- Working voltage: 5v
- Weight: 2.2g (Including antenna)
- Dimension: 13mmx11mmx3mm
- Firmware Version: ExpressLRS v3.0 pre-installed
- FW Target: RadioMaster RP1/2 2400 RX
- Bus interface: CRSF
User Manual
Included:
- RadioMaster RP1 V2 2.4GHz ELRS nano receiver x 1
- 65mm UFL 2.4Ghz T Antenna x 1
- User Manual x 1
There are no reviews yet.