Category Name, Frames, Micro/Whoop
Fractal Engineering Fractal 75 2.00mm Bottom Plate
A 2.0mm bottom plate and motor screws for a Fractal 75 Build! This is slightly thicker than the frame included in the Fractal 75 Lite Kit, for those pilots that want more strength in their frame.
** IMPORTANT NOTE:
This is only the bottom plate and 14 motor screws for a Fractal 75 build. This does not include any of the TPU pieces used to secure the battery or camera nor any grommets. You will have to print your own or already have them from a previous build or kit.
A snippet of the FEA optimization Fractal Engineering performed, ensuring the stress gets spread out across the whole structure without concentrations.
$6.99
Features:
- 75mm diagonal, squished X geometry, for 31mm props
- 2.0mm Carbon Fiber / Individual Nylon ducts hybrid construction
- Low-profile camera mount, no props in view, no tilt offset
- Low Center of Gravity, by bringing the AIO closer to the frame/motors
- Allows mounting with USB pointing up for easy accelerometer calibration
- No need for a canopy as all electronics are tucked safely between the ducts
- Maximum rigidity where it matters most; connecting the motors to the FC
- Easy maintenance, break one duct, replace only the single duct
- Lightweight, less than 19.5g with HM DiamondF4
Included:
- Fractal 75 2.0mm Bottom Plate x 1
- M1.4x5mm steel machine screw for motors x 14
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
There are no reviews yet.