Electronics, Flight Controllers
Happymodel X2 AIO F4 Flight Controller SPI ELRS RX 2-4S 12A ESC
The Happymodel ELRS X2 AIO Flight Controller is the direct replacement for the Mobula7 HDZero.
It comes with an integrated SPI 2.4GHz ELRS receiver and 12A Blheli_S ESC which supports 2-4S batteries. Bigger mosfet supports high to 12A currents and would be better for a 2-4S toothpick drone or long-range FPV drone. The 2.4GHz ExpressLRS receiver is equipped with the SX1280 radio frequency chip with high sensitivity, high packet rate, and low latency. Featuring an MPU 6000 SPI sensor and OSD, this board is the perfect addition to your FPV build.
Availability:
Out of stock
$54.99
Out of stock
Features:
- 25.5 x 25.5mm Mounting Pattern
- F4 Flight Controller
- SPI ELRS Receiver
- 2-4S Lipo Input
- MPU 6000 SPI
- 12A ESC
- OSD
Specifications:
- Amperage meter scale setting 470
- Voltage meter scale setting 110
F4 FLIGHT CONTROLLER
- MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
- Receiver: Built-in SPI ExpressLRS 2.4GHz
- OSD: Built-in Betaflight OSD(SPI Control)
- Firmware Target: CRAZYBEEF4SX1280
- Sensor: MPU-6000(SPI connection)
- Mounting Pattern: 25.5×25.5 M2
- Power Supply: 2-4S Lipo battery
- ESC: Built-in 12A Blheli_s
- BEC: Built-in 5V 1A
ONBOARD SPI ELRS RECEIVER
- Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
- Antenna: Onboard SMD ceramic antenna
- Receiver Protocol: SPI ExpressLRS
- Telemetry output Power: <12dBm
- RF Frequency: 2.4GHz
ONBOARD 4-IN-1 ESC
- Default protocol: DSHOT150/DSHOT300/DSHOT600
- Currents: 12A continuous peak 15A (5 seconds)
- Power supply: 2-4S LiPo/LiPo HV (7v/17v)
- Factory firmware: F_H_40_REV16_8.HEX
- Support BLHeliSuite programmable
- MCU upgraded to EFM8BB21
Included:
- 1 x Happymodel X2 AIO Board F4 FC
- 1 x Amass XT30U-M Connector
- 1 x Hardware Set
- 2 x 20AWG Wire
- 4 x Grommets
There are no reviews yet.