You may be interested in…
-
1s Batteries, Batteries/Chargers
Flywoo Explorer 1S 450mAh 80C Battery 4.35v GNB27 V2 (4 pack)
Flywoo Explorer series batteries are specially designed for long flight time and all are high voltage battery. Using this battery will give you a significant increase in flight time as well as a bit more power over the stock battery.
SKU: FW.BATT1S.450MAH.80C.4PACK. -
Radio Accessories, Radio Transmitters, TBS
TBS Tango 2 Module Bay Add-On
This is an after-market mod to add a module bay to your Tango 2. The module bay sticks to the back of your Tango 2 and plugs into the receptacle board of your Tango 2.
Installation process
- Install the FPC cable to the PCB.
With the blue side facing up, lift the lock and slide the cable in then lock it down. - Feed the cable through the bottom and place the PCB to the module bay.
- Turn the module bay around to make sure everything fits accordingly.
- Close the case with the 2 screws provided
- Use a dremel, knife or solder tip to cut a small hole accoridng to the outline.
- Slide the flex PCB through the drilled case.
- Clean the back surface and tape the Tango 2 module bay down
- Â Install the FPC cable into the receptacle.
- Close the Tango2 case, and you’re done!
*IMPORTANT NOTE
*The first batch of Tango 2 shipped WITHOUT module bay capability. Please verify that there is a connector (in pictures above) before purchasing this add-on. Upgrade PCB’s can also be purchased!
Also, whenever opening up your Tango 2 in future, you will need to open the module bay and release the flex PCB from the socket.*We have discovered that XJT mini modules are using a pin that we did not anticipate for use in our module bay. It appears that the XJT mini module is the only module on the market that uses this pin.
Due to a hardware incompatibility between the XJT mini module and the Tango 2 (V2 and up) boards, the Tango 2 will NOT be able to support the XJT mini module.
SKU: TBS.T2ModB - Install the FPC cable to the PCB.
-
Propellers, Toothpick
Gemfan 3016-3 Hurricane 3″ (1.5mm Shaft) Propeller (4 pack)
This blade profile is similar to the Hurricane 3018, except in a triblade form! A perfect prop for a lightweight 3″ toothpick. Provides agile flight at a low weight at barely over 1g. Great replacement for Darwin Baby Ape quad and similar requiring 3″ prop with 1.5mm shaft.
SKU: n/a
Cart totals
Subtotal | $1,508.34 |
---|---|
Shipping |
Shipping to NY. |
Tax | $0.00 |
Total | $1,508.34 |