-13%
, ,

Happymodel CrossF4 F411 1-2S 5A AIO Whoop Flight Controller with UART ELRS v3.0 receiver – ELRS 2.4gHz

Availability:

Out of stock


HappyModel keeps them coming! Now with yet another fantastic whoop AIO.  The HappyModel CrossF4 1-2S AIO Whoop Flight Controller (F4 FC / 5A 4in1 ESC) – Featuring  F411 Flight Controller, with a built in serial UART ELRS for V3.0.

 

NOTE: Onboard blackbox enable method:
-Type the following command to CLI:
-set blackbox_device = SPIFLASH
-set flash_spi_bus = 2
-resource FLASH_CS 1 a14

Pay attention: Bind procedure is the same like Happymodel EP1/EP2 receiver, as you need to upgrade your ExpressLRS TX module to V3.X version first.

Alternative-Binding-Method-for-UART-Based-ELRS-RX

 

Onboard blackbox enable method:

Type the following command to CLI:
set blackbox_device = SPIFLASH
set flash_spi_bus = 2
resource FLASH_CS 1 a14
save

$38.99 $44.99

Out of stock

Features:

  • BMI270 IMU (SPI connection)
  • Serial UART ELRS V3.0 receiver
  • Built-in 5V 1A BEC

Specifications:

  • Firmware target: CRAZYBEEF4DX4.3.2
  • MCU:STM32F411CEU6 (100MHz, 512K FLASH)
  • Sensor: BMI270(SPI connection)
  • Power supply: 1-2S Lipo Lihv battery input (DC 2.8V~8.7V)
  • Built-in 5A(each) Blheli_S 4in1 ESC Dshot300 ready
  • Built-in Betaflight OSD(SPI Control)
  • Built-in UART ExpressLRS 2.4Ghz receiver(Default firmware ExpressLRS v3.0.1)
  • Built-in 5V 1A BEC
  • Built-in voltage detection and current sensor
  • Built-in Onboard flash 16Mb for Blackbox

Onboard 4in1 ESC

  • MCU: EFM8BB21
  • Power supply: 1-2S LiPo/LiPo HV (2.8v~8.7v)
  • Currents: 5A continuous peak 6A (5 seconds)
  • Support BLHeliSuite programmable
  • Default Factory firmware: S_H_50_REV16_8.HEX
  • Support ESC Protocol: DSHOT150/DSHOT300/DSHOT600

 Onboard UART ExpressLRS 2.4GHz Receiver

  • Packet Rate: 25Hz/50Hz/150Hz/250Hz/500Hz
  • RF Frequency: 2.4GHz
  • Antenna: enameled copper wire 31mm length
  • Telemetry output Power: <12dBm
  • Receiver protocol: CRSF
  • Default firmware version: ExpressLRS V3.0.1
  • The same hardware with Happymodel EP1
  • Could update firmware via ExpressLRS configurator

Included:

  • HappyModel CrossF4 F411 1-2S 5A 8Bit AIO Whoop Flight Controller – ELRS 2.4gHz x 1
  • Mounting Hardware x 1
  • Wiring Harness x 1
SKU: HM.CROSSF.FC.ELRS Categories: , ,

Based on 0 reviews

0.0 overall
0
0
0
0
0

Only logged in customers who have purchased this product may leave a review.

There are no reviews yet.

Join Waitlist We will inform you when the product arrives in stock. Please leave your valid email address below.

No fields found, please go to settings & save/reset fields