You may be interested in…
-
Category Name, Frames, Micro/Whoop
Fractal Engineering Fractal 75 Pro Max Frame Lite Kit
The long awaited F75 Pro Max Lite Kit is here!
This is designed for prop guards that fit 45mm props such as the Meteor75 Pro. Just like its predecessor the F75 you can replace a single duct if it breaks rather than the entire whoop frame.
FEA optimization test performed, ensuring the stress gets spread out across the whole structure without concentrations
SKU: FE.F7PMAX.FRAME. -
Radio Accessories, Radio Transmitters, TBS
TBS Tango 2 Module Bay Add-On
This is an after-market mod to add a module bay to your Tango 2. The module bay sticks to the back of your Tango 2 and plugs into the receptacle board of your Tango 2.
Installation process
- Install the FPC cable to the PCB.
With the blue side facing up, lift the lock and slide the cable in then lock it down. - Feed the cable through the bottom and place the PCB to the module bay.
- Turn the module bay around to make sure everything fits accordingly.
- Close the case with the 2 screws provided
- Use a dremel, knife or solder tip to cut a small hole accoridng to the outline.
- Slide the flex PCB through the drilled case.
- Clean the back surface and tape the Tango 2 module bay down
- Â Install the FPC cable into the receptacle.
- Close the Tango2 case, and you’re done!
*IMPORTANT NOTE
*The first batch of Tango 2 shipped WITHOUT module bay capability. Please verify that there is a connector (in pictures above) before purchasing this add-on. Upgrade PCB’s can also be purchased!
Also, whenever opening up your Tango 2 in future, you will need to open the module bay and release the flex PCB from the socket.*We have discovered that XJT mini modules are using a pin that we did not anticipate for use in our module bay. It appears that the XJT mini module is the only module on the market that uses this pin.
Due to a hardware incompatibility between the XJT mini module and the Tango 2 (V2 and up) boards, the Tango 2 will NOT be able to support the XJT mini module.
SKU: TBS.T2ModB - Install the FPC cable to the PCB.